Dating stanley 110 plane
The 60 1/2 on the other hand is the low-angle 12 1/2-degree model.Both models are useful, but I think it’s deceptive to present both as necessary planes.
This information was originally on Jay Sutherland's website, but it went inactive sometime in 1999 or 2000. The screw may then be tightened, by a turn with thumb and finger; and the Cap iron will serve as a convenient handle, or rest, in whetting or sharpening the cutting edge of the Plane Iron." There you have it, in all its gory, why the circular hole was repositioned, after it being at the top of the blade for some 100 years. However, the patent drawing for the change shows what I believe is the real reason for the change - the circular disk, on the lower end of the lateral adjustment lever, loses its ability to engage the slot provided for it (in the cutter) when the iron is nearly used up.In actuality, this plane is not a smoothing plane so much as a trimming, easing, end-grain planing plane and we seldom if ever use it for surface smoothing as such, though we do use it for edge planing on narrow boards.I’ve used Stanley block planes since I was 15 years old; 46 years. Block planes are designed to reduce vibration by placing the bevel of the cutting iron uppermost instead of downwards as in the case of regular smoothing planes.I like both planes and like their apron plane especially, because it’s simple and compact and the most common need for a block plane, and the reason they were often called an apron plane, is because we use them to ease the corners of our work.These corners are usually in awkward places like the top edges of drawers, the inside corners of frames and recesses and so on.Millers Falls made planes for other outlets beginning (I believe) around 1935 or 1936.This notion is supported by the change from the now-coveted original feature set presented in the initial release.I have two block planes from Veritas that I like: Here they are side by side.These are fully adjustable using the mechanics developed by Veritas in their larger bench planes.The Stanley and Record Irwin range of block planes feature hardened and tempered chrome carbon alloy steel cutting irons, which take a keen cutting edge.Most block planes today feature fine grey iron cast soles that give good stability and wear resistance.